Mauch 058: PC - 2x 15A Ideal Diode / BattShare / Red-Black cable set

$ 78,28
incl. 19% VAT , plus shipping costs
Available immediately
Delivery time: 2 Workdays

General

The PC – 2x 15A is a dual-supply current-sharing controller that incorporates MOSFET ideal diodes. The diodes block reverse and shoot-through currents during start-up and fault conditions. Their forward voltage is adjusted to share the load currents between the supplies. Unlike other sharing methods, no shared bus or trim pins on the supply are required.

The dual functionality of this device allows it to be integrated into applications where either a redundant power supply is required, or a 50/50 current share between two power supplies, even if they are on two different main batteries (GND bridge required).

The PL - 2x15A can also be used in standard remote-controlled applications without a Power-Cube and flight controller. For example, you can directly connect 2x 2S LiPo (regardless of the capacity) to the two inputs and the output to the receiver or servo rail. This provides a redundant power supply with a total capacity of mAh / LiPo 1 plus mAh / LiPo 2.

 

Included:

  • 1x PC - 2x 15A Board
  • 2x Input cables / Molex / Click-Mate / 2.0 / L=200mm, in red/black
  • 4x Output cables / JR Servo connector / L=200mm, in red/black
  • 1x Transparent shrinking tube

 

Note: The cables are delivered separately and need to be soldered onto the board. This allows the cable length to be adjusted before installation to match the system Setup.

Item information Value
Manufacturer: Mauch
SKU: M058
GTIN: 705604300586

Manufacturer information:

Mauch

General

This cable is designed for the PL series BECs to connect them to any flight controller with a JST-GH 6p connector.

 

Examples include: Pixhawk 3, PixRacer, etc.

 

Length: 150mm (standard length)

Item review: 0 from 5 Stars

Write the first review for this item and help others make a purchase decision!:

Contact data
Question about item
Please answer the question