Pix32 V6 Standard Baseboard Ports Pinout:
Pix32 v6 Baseboard Ports is compatible with Pix32 v5 Baseboard and vice versa.
Due to the difference in Pin map, the following ports shaded in red in the diagram below will be non-functional when using a Pix32 v6 FC on a Pix32 v5 Baseboard.
- Pin 1 starts from the flight Controllers "Left side". All connectors are JST GH 1.25 mm Pitch unless noted otherwise.
- Pin 1 (red) - Signal VDD5V_BRICK1 (in) - Voltage +5V
- Pin 2 (black) - Signal VDD5V_BRICK1 (in) - Voltage +5V
- Pin 3 (black) - Signal CURRENT1 (in) - Voltage +3.3V
- Pin 4 (black) - Signal VOLTAGE1 (in) - Voltage +3.3V
- Pin 5 (black) - Signal GND (in) - Voltage GND
- Pin 6 (black) - Signal GND (in) - Voltage GND
Telem 2 Port
- Pin 1 (red) - Signal VCC (in) - Voltage +5V
- Pin 2 (black) - Signal UART5_TX(out) - Voltage +3.3V
- Pin 3 (black) - Signal UART5_RX (in) - Voltage +3.3V
- Pin 4 (black) - Signal UART5_CTS (in) - Voltage +3.3V
- Pin 5 (black) - Signal UART5_RTS (out) - Voltage +3.3V
- Pin 6 (black) - Signal GND (in) - Voltage GND
USB Port
- Pin 1 (red) - Signal VBUS - Voltage +5V
- Pin 2 (black) - Signal DM - Voltage +3.3V
- Pin 3 (black) - Signal DP - Voltage +3.3V
- Pin 4 (black) - Signal GND - Voltage GND
For Pix32 v6 with SN number before 'xxxx xxx 20221113', (SN can be found on the packaging), I2C port is connected as follows:
- pin 2 -> I2C4_SCL (3.3V)
- pin 3 -> I2C4_SDA (3.3V)
Item review: 0 from 5 Stars
