Holybro - PM06 V2-14S Power Module

24,98 €

incl. 19% VAT , plus

This PM06 Power Module supplies clean 5.2V to flight controller from the battery and provides current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable, along with integrated power distribution for 4 ESCs. It comes with pre-soldered wires, capacitor, and XT60 connector.

Specifications：

Input voltage (10S version): 2S-10S
Input voltage (14S version): 2S-14S
PCB Cont. Current Rating: 70A
PCB Burst Current Rating: 120A (<60 Sec)
Output: DC 5.2V & 3A Max
Ouput Max Power : 18W
Voltage Divider: 18.182
Amperes per Volt: 36.364

Low stock level

Delivery time: 2 Workdays

Specifications：

Input voltage (10S version): 2S-10S
Input voltage (14S version): 2S-14S
PCB Cont. Current Rating: 70A
PCB Burst Current Rating: 120A (<60 Sec)
Output: DC 5.2V & 3A Max
Ouput Max Power : 18W
Voltage Divider: 18.182
Amperes per Volt: 36.364

Please Note:

The XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60A burst current (< 60 Seconds). If a higher current is being used, the plug type and wire size should be changed accordingly. You can refer to this chart for reference.
This PM02 Power Module uses analog data output and is not compatible to the Pixhawk 5X & 6X (Requires a digital PM like PM02D).