PPK mapping with centimeter accuracy. Use fewer GCPs
Why camera synchronization is so important?
Usually autopilot triggers the camera and records the coordinate it has at that moment. When the drone is flying at 20 m/s and GPS works at 5 Hz, that means your autopilot will have position readings only each 4 m, which is not suitable for precise georeferencing. In addition, there is always a delay between the trigger and the actual moment the photo is taken.
Reach eliminates the delay
Reach solves the problem of positioning by connecting directly to the camera hot shoe port, which is synced with the shutter. The time and coordinates of each photo are logged with a resolution of less than a microsecond. This method allows GCPs to be used only to check your accuracy.
NTRIP or another Reach as a base Station
To calculate centimeter-precise coordinates in PPK and RTK, Reach needs corrections from a base station. It could be either another Reach receiver or an NTRIP service. VRS is also supported.
Compatibility: Reach M2 and M+ work seamlessly with other Reach receivers over any link and are compatible with any other receiver that supports RTCM3 and NTRIP.
Reach M+ and Reach RS+
Provides robust performance and quick initialization, allowing work on long baselines.
- RTK up to 10 km
- PPK up to 20 km
- Time to fix 1-2 Minutes
- Frequency bands Single-band
- RINEX logging update rate Up to 14 Hz
- Reach M+
- USB cable
- USB-OTG cable
- JST-GH 6-pin to jumper pin cable
- JST-GH 5-pin to jumper pin cable